(2-Pack) Tama MS450DBK Iron Works Tour Round Base Straight Microphone Stands and Cables

Iron Works’ sturdy zinc, die-cast adjustment collar will be appreciated by users who’ve been thwarted by the performance failure of flimsy plastic collars.

Not only does the thumb nut’s larger, sure-grip design allow greater leverage for faster, easier set-up and breakdown, its high quality zinc threads and walls are built to handle pressure for years to come.

Anyone who has used existing boom stands is familiar with the following potential mishap: Performer attempts a slight adjustment of mic stand by rotating the boom arm in the stand around few degrees—but with an undesired result—the twisting force is just enough to loosen the plastic ring inside the adjustment collar. Having lost its grip on the upper telescoping shaft, the boom arm, and microphone, sink downward, possibly even falling to the ground. No more. Finally, TAMA has addressed this common problem by utilizing a specially designed ring with an anchor at the bottom, which sits in the mic pipe’s slot. The ring does not rotate, so adjustment collar’s grip cannot fail.

Commonly, machined threads are the means of attaching a microphone stand to a cast base. But threads are easily damaged, and if a microphone stand is handled roughly, the threaded end of the lower pipe can be broken. TAMA’s simple re-design eliminates this weak link. The TAMA Round Cast base has an unthreaded pocket that accepts the lower pipe. A T-bolt on the underside of the cast base then fixes the pipe to the base. Not only is this solution more durable, users will find set-up and breakdown to be easier too.