Building on the popularity and acceptance of the RØDE NTG2, the NTG4+ features an all-new condenser capsule with low noise, high sensitivity and the convenience of on-board equalisation/level control via digital switching.
The NTG4+ is the very first microphone to feature an in-built battery that provides 150+ hours of operation with the convenience of USB charging.
Intuitive Digital Switching
Control the in-built high-pass filter, pad and high frequency boost using convenient digital switching on the microphone body. Persistent states ensure your settings are retained when the microphone is switched off.
Internal Battery (NTG4+)
Provides 150+ hours of operation from with a charge time of only two hours. The included MicroUSB cable makes charging simple and convenient, meaning the mic can be charged via a computer, power-brick or even your car.
The NTG4 & NTG4+ both feature an all-new condenser capsule from RØDE with low noise floor, higher sensitivity and a rich, smooth character.
Broadcast sound quality
Low noise circuitry
Internal rechargeable lithium battery, supplying over 150 hours operation
Fully charged in under two hours via MicroUSB
Rugged metal construction
Convenient digital switching
High Frequency Boost
High Pass Filter (Flat/75Hz)
MicroUSB cable included
Ten year extended warranty with online registration
Acoustic Principle: Line Gradient
Polar Pattern: Supercardioid
Address Type: End
Frequency Range: 20Hz - 20kHz(selected HPF @75Hz)
Output Impedance: 200Ω
Maximum SPL: 135dB SPL (@ 1kHz, 1% THD into 1KΩ load)
Sensitivity: -32.0dB re 1 Volt/Pascal (25.00mV @ 94 dB SPL) +/- 2 dB @ 1kHz
Equivalent Noise Level (A-weighted): 16dB-A
Power Options: +48V phantom power required from mixer or interface; inbuilt rechargeable battery
Dimensions: 278mmH x 22mmW x 22mmD
Output: 3-pin XLR output