Schatten Designs C-12 Std Cello Pickup with Rosewood Jack Assembly

Schatten Designs C-12 Std Cello Pickup with Rosewood Jack Assembly

All New And Redsigned - Stick-On Pickup Attaches To The Existing Bridge

      ...you don't have to change or modify the bridge on your cello in order to get a good sounding pickup.

A combination of tremendous sound coupled with amazing response. This pickup is truly one of a kind.

     The new C-12 Std. model cello pickup is now available and it offers even more brilliance and clarity of sound than our previous C-12 unit.

A Pickup System When You Need It
     As you can see by the picture, the piezo sensing unit is quite small and light in weight. It is only 1/8" thick, 1/4" wide, and 1 1/2" in length. It goes on to your cello bridge with a little bit of the special putty that comes supplied with the pickup. 
     The pickup system can be installed on your cello in about 3 minutes and was designed to allow you to install and remove it quickly and easily.

 There is no acoustic degradation or loss of normal acoustic tone or volume. The pickup has excellent volume, and is strong and sweet throughout its' full dynamic range.

Features:

• Ease of installation, the pickup adheres to the bridge with a little bit of the supplied non-marring putty.
• The C-12 comes ready to go and is pre-wired to a rosewood faced jack assembly that clamps quickly and securely between the center strings just above the tail piece.

Clean, clear sound reproduction.

This pickup has been designed to operate properly and sound terrific without the use of a preamp when plugged into any 'normal' amp (guitar amp, bass amp, etc.). As with any pickup, the sound can be further enhanced with an outboard preamp. If you require the added ability to be able to plug directly into a P.A. or mixer then you may wish to add either one of our new Mini Pre belt clipable preamps or one of our Preamp/DI units to your pickup system.