Temple Audio 4X MOD Pro V2 4-Way Buffer Module for Templeboard Pedalboards

4 CABLES? WE'VE GOT YOUR FX LOOP COVERED.

The 4X MOD Pro V2 mounts in the Modular End Panel of your Templeboard and allows you to route 1⁄4” inputs and outputs through the side of your board.

The 4X MOD Pro V2 offers four buffers in one compact module and is the perfect solution for those using the “four cable method”.

The 4X MOD Pro features two buffered inputs and two buffered outputs. Whatever 1⁄4” signal you send into one jack will carry on to the corresponding jack on the other side.

INPUT/OUTPUT JACKS

LOOP A INPUT - Buffered input. Plug guitar in here.*

LOOP A OUTPUT - Buffered output. Out in front of the amp.*

LOOP B INPUT - Buffered input. Input from amp’s FX loop send.*

LOOP B OUTPUT - Buffered output. Output to amp’s FX loop return.*

*This is the recommended configuration for the 4-cable method, but the 4X Pro V2 can be used for any setup requiring 2 inputs and 2 outputs.

SWITCHES

1 - engage/disengage buffer on LOOP A INPUT

2 - engage/disengage buffer on LOOP A OUTPUT

3 - engage/disengage buffer on LOOP B INPUT

4 - engage/disengage buffer on LOOP B OUTPUT

5 - engage/disengage AUTO LOOP

AUTO LOOP allows you to quickly switch between rigs with or without FX loops. If no cables are present in the LOOP B jacks, your FX loop pedals are automatically re-routed to LOOP A OUTPUT (after your drive pedals and before the amp).

The 4X MOD Pro V2 is an excellent choice for setups that use the Four Cable Method. This setup lets you place some of your pedals (I.e. compressors, overdrives) before your amplifier’s preamp/EQ section and the rest of your pedals (i.e. reverbs, delays) in the FX loop after the preamp/EQ section.